Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

For models: TWS-1686525

Step-by-step guide

Instructions to remove the chassis cover/lid can be found here: Removing the Chassis Cover (TWS-1686525)

  1. Align and install the processor on the carrier.



  2. Carefully flip the heatsink. Then install the carrier assembly on the bottom of the heatsink and make sure the guide pin is located in the correct direction.



  3. Always start with CPU0 first. Remove the CPU Socket protection cap. Locate the CPU socket’s guide pin.



    NOTE: Only new heatsinks comes with pre-applied thermal grease. If heatsink is removed, clean processor and heatsink using an alcohol solvent. Apply new thermal grease before re-installing heatsink.

  4. Carefully flip the heatsink. Align the heatsink with the CPU socket by the guide pin and make sure the guide pin is located in the correct direction. Then place the heatsink onto the top of the CPU socket.


  5. To secure the heatsink, use a T30 Security Torx to tighten the screws in a sequential order (1→2→3→4).
    NOTE: When disassembling the heatsink, loosen the screws in reverse order (4→3→2→1).

  6. Repeat the procedures described earlier to install the second processor and heatsink.


  7. Place the CPU air duct back and screw it to the chassis.




  • No labels